E-Shine Machery Co., Ltd
E-Shine Machery Co., Ltd
E-Shine Machery Co., Ltd Home > Products > Vacuum Hot Press Machine > Vacuum Hot Press Machine
Vacuum Hot Press Machine
  • Product Description
  • Specification

    1. Vacuum system:

    1-1. Utilizes upward pull motion for hydraulic cylinder in the vacuum hood, which supports to provide stability and prevent oil leakage.
    1-2. Using MIT vacuum pump with high vacuity and low noise. Imported ball valves are used to offer high flow rate and fast vacuum extraction.

    2. In / out-molds:

    Designed with special Mold Frame devices, it is easy and convenient to setting and operate.

    3. Front ejector:

    Using double-layer oil-less bearings, protected with a dust seal.

    4. Monitoring design:

    Overall monitoring on machine actions, pressure and flow rate, and warning messages and records.

    5. Hydraulic circuit design:

    Proportional Pressure and flow ratio system is designed for easily changing the pressure and speed setting.

    6. Electrical control system:

    6-1. Precise temperature controlled is using PID calculations, temperature can be adjusted by the man-machine interface.

    6-2. The module saving function includes temperature, pressure/ flow rate, time and function settings.

    6-3. Heating system: using SSR solid relay with fast heat-up without exceeding the limit.

    6-4. Mold calibration: slow mode calibration function is provided. To calibrate the mold, simply press up/down key to complete the mold position setting.


    TYPE 100TON 150TON 200TON 250TON 300TON 500TON
    Stroke (mm) 350mm 250mm 250mm 250mm 250mm 300mm
    Upper heater Plate (mm) 400x400 450x450 510x510 600x600 600x600 850x850
    Lower heater Plater (mm) 445x490 500x500 540x600 650x720 650x720 850x920
    Mold in-out plate (mm) 510x540 550x580 620x650 725x725 725x725 940x980
    Piston diameter (mm) 250mm 300mm 350mm 400mm 450mm 560mm
    Electrical heater (KW)     22KW 34KW 34KW 34KW
    Motor (HP) 15HP 15HP 15HP 15HP 10HP*2 10HP*2
    Total power (KW)     40KW 48KW 52KW 52KW
    Mold opening method-開模方式 0RT:上升/下降 (Ascending/Descending)
    1RT: 模具出入 (Sliding mold In / out)
    2RT: 前頂上模 (Front ejector for upper mold plate)
    3RT: 前頂上、中模 (Front ejector for upper and middle mold plate)
    4RT: 頂模 (3RT with a hydraulic cylinder at the bottom)
    Short name: VCC
top