E-Shine Machery Co., Ltd
E-Shine Machery Co., Ltd
E-Shine Machery Co., Ltd Home > Products > Rubber (Silicone) Injection Molding Machine > Rubber (Silicone) Injection Molding Machine
Rubber (Silicone) Injection Molding Machine
  • Product Description
  • Specification

    1. Feeding system:

    Specially made screw is used to achieve optimal exhaustion for the material. Heating oil is circulated to avoid jamming while increasing the feeding speed and stabilizing the temperature of the fed material.

    2. Injection system:

    German made resistance scale, and “cc” is used as the measuring unit. The temperature is controlled by circulating heating oil to achieve accurate injection.

    3. Cold runner mechanism:

    The sliding plate system is used to separate the injecting and curing function. Cold rubber compound is used for injection, and curing process is on the other plate to achieve almost zero waste material after injecting molding.

    4. Monitoring design:

    Full-area design to monitor the machine operation, pressure, flow rate, warning sign and warning record.

    5. Hydraulic circuit design:

    Proportional Pressure and flow ratio system is designed for easily changing the pressure and speed setting.

    6. Electrical control system:

    6-1. Precise temperature controlled is using PID calculations, temperature can be adjusted by connecting the man-machine interface.

    6-2. The module saving function includes temperature, pressure/flow rate, time, injection position, ascending/descending position, and function settings.

    6-3. Heating system: using SSR solid relay with fast heat-up without exceeding the limit.

    6-4. Mold adjustment: slow mode adjustment function is provided. Simply to press up/down key to complete the mold position setting.


    TYPE 100TON 200TON 300TON 400TON 500TON
    Stroke (mm) 400mm 500mm 600mm 600mm 600mm
    Working table (mm) 450x450mm 503x508mm 580x600mm 700x700mm 950x950mm
    Upper heater Plate (mm) 450x450mm 503x508mm 580x600mm 700x700mm 950x950mm
    Lower heater Plater (mm) 460x460mm 495x508mm 580x600mm 700x700mm 950x950mm
    Mold in-out plate (mm) 460x500mm 490x570mm 581x660mm 704x760mm 950x1010mm
    Piston diameter (mm) 250mm 350mm 450mm 500mm 560mm
    Inject Capacity (cc) 1000CC 1500CC 3000CC 4000CC 5000CC
    Electrical heater (KW) 12KW 16KW 18KW 25KW 35KW
    Motor (HP) 10HP 15HP 20HP 20HP 25HP
    Total power (KW) 19.5KW 27KW 33KW 40KW 68KW
    Mold opening method-開模方式 0RT:上升/下降 (Ascending/Descending)
    1RT: 模具出入 (Sliding mold In / out)
    2RT: 前頂上模 (Front ejector for upper mold plate)
    3RT: 前頂上、中模 (Front ejector for upper and middle mold plate)
    4RT: 頂模 (3RT with a hydraulic cylinder at the bottom)
    Remarks : Single Shafts , Single Motive power
top