Oil Seal Vacuum Molding Machine
1. Vacuum system:
Uses MIT vacuum pump for high vacuity and low noise. Imported ball valves are used to offer high flow rate and fast vacuum extraction.
2. In / out-molds
With special Mold Frame devices , it is easy and convenient to set and operate.
3. Front ejector:
Using double-layer oil-less bearings, protected with a dust seal.
4. Monitoring design:
Overall monitoring on machine actions, pressure and flow rate, and warning messages and records.
5. Hydraulic circuit design:
Proportional Pressure and flow ratio system is designed for easily changing the pressure and speed setting.
6. Electrical control system:
6-1. Precise temperature controlled is achieved using PID calculations; temperature can be adjusted by the man-machine interface.
6-2. The module saving function includes temperature, pressure/ flow rate, time and function settings.
6-3. Heating system: using SSR solid relay with fast heat-up without exceeding the limit.
6-4. Mold calibration: slow mode calibration function is provided. To calibration the mold; simply press up/down key to complete the mold position setting.
|Working table (mm)||335x380mm|
|Mold Frame dimensions (mm)||380x382mm|
|Piston diameter (mm)||250mm|
|Electrical heater (KW)||7.2KW|
|Total power (KW)||15KW|
|Vacuum Motor (HP)||3HP|
|Mold opening method-開模方式||
2RT: 拉上模(Front ejector to pull upper mold)
3RT: 拉上模、掀模仁(2RT With a ejector plate)