E-Shine Machery Co., Ltd
E-Shine Machery Co., Ltd
E-Shine Machery Co., Ltd Home > Products > High-Speed Hot Press Molding Machine > High-Speed Hot Press Molding Machine

High-Speed Hot Press Molding Machine

  • Product Description

  • Specification

    1. In/Out molds:

    Designed with special isolating devices to prevent wearing of the heat plate and the  in/out-mold plate.

    2. Front ejector:

    Using double-layer oil-less bearings, protected with a dust seal.

    3. Monitoring design:

    Overall monitoring on machine actions, pressure and flow rate, and warning messages and records.

    4. Hydraulic circuit design:

    Fully proportional hydraulic system, pressure and speeds can be easily adjusted.

    5. Electrical control system:

    5-1. Precise temperature controlled is using PID calculations, temperature can be adjusted by the man-machine interface.

    5-2. The module saving function includes temperature, pressure/ flow rate, time and function settings.

    5-3. Heating system: using SSR solid relay with fast heat-up without exceeding the limit.

    5-4. Mold calibration: slow mode calibration function is provided. To calibrate the mold, simply press up/down key to complete the mold position setting.

    TYPE 100TON 150TON 200TON 250TON 300TON 500TON
    Stroke (mm) 350mm 250mm 250mm 250mm 250mm 300mm
    Upper heater Plate (mm) 400x400 490x500 510x510 600x600 600x600 850x850
    Lower heater Plater (mm) 445x450 490x500 540x560 650x600 650x650 850x850
    Mold in-out plate (mm) 445x500 550x560 540x570 650x650 650x680 855x880
    Piston diameter (mm) 250mm 300mm 350mm 400mm 450mm 560mm
    Electrical heater (KW)     22KW 34KW 34KW 34KW
    Motor (HP) 15HP 15HP 15HP 15HP 10HP*2 10HP*2
    Total power (KW)     40KW 48KW 52KW 52KW
    Mold opening method-開模方式 0RT:上升/下降 (Ascending/Descending)
    1RT: 模具出入 (Sliding mold In / out)
    2RT: 前頂上模 (Front ejector for upper mold plate)
    3RT: 前頂上、中模 (Front ejector for upper and middle mold plate)
    4RT: 頂模 (3RT with a hydraulic cylinder at the bottom)